EZ Set Up

Important! (Caution during EZ Set Up):

Do not press POWER on the recorder or remote control.

The EZ Set Up function automatically sets the tuner channels and clock when the antenna cable is connected to the rear of the recorder and the power plug is then connected to an AC outlet.

POWER

OPEN/CLOSE

CHANNEL TIMER ON/OFF

 

 

REC

 

POWER

 

Important!

When using a cable box:

See “CATV or Satellite Receiver Connections” on page 21.

Leave POWER on the cable box turned on and select a channel that carries EDS signals.

1 Make sure that the antenna cable is connected. For connection configuration, refer to “Basic Connection” on page 19.

2

3

Connect the power plug of the recorder to an AC outlet.

The tuner channels and clock will automatically be set.

This recorder can monitor and use time-signals (EDS signals), which are provided by some TV stations, to automatically adjust the clock. This recorder automatially searches EDS signals, but if you are in a hurry to use timer recording or know the channel of the EDS signal carrier in you area, follow the procedure in “Auto Clock Setting” or “Manual Clock Setting”.

During Auto Channel Setting

 

During Auto Clock Setting

 

EZ Set Up complete

 

 

 

 

 

 

 

 

 

 

Channel number is increasing.

• Front Panel Display is turned off when settiing “CLOCK DISP” in “OPTION SETUP” to “OFF”.

NOTE

If power is supplied to the recorder before the cable is connected, EZ Set Up will not be able to preset the channels into memory. If this occurs, press RESET in the front of the recorder (See page 101). EZ Set Up function will work again.

If the power is turned on during EZ Set Up, the Auto Channel setting will be interrupted and the turner channels will not be able to be preset.

Auto Clock Setting may take several minutes.

If the Auto Clock Setting is not completed within 30 minutes, there may be no channels with EDS signals. In this case, set the clock manually. (See “Manual Clock Setting” on page 26.)

If the antenna signal is weak, the Auto Clock Setting function may not operate.

During initial channel setting, the channels are set into the AIR channel setting. To watch CATV channel, select “CATV” on the CHANNEL PRESET screen. (See “Channel Setting” on page 24.)

23

DV_RW2U#p19-23.p65

23

03.1.9, 7:32 PM

Page 23
Image 23
Sharp DV-RW2U manual Important! Caution during EZ Set Up, Power