Setting up Network Scanning

Checking your IP address and the connection

To check the machine’s IP address and verify that the machine is able to communicate on the network, follow these steps.

1 Press INFO , then until [NETWORK INFORMATION] appears.

2 Press .

•If the machine has automatically received an IP address and is able to communicate, [IP ADDRESS/DHCP: ON] will appear on the top line of the display, followed by the IP address on the bottom line. To show the

machine’s host name, press .

•If a static IP address has been entered in the machine and the machine is able to communicate, [IP ADDRESS/DHCP: OFF] will appear on the top line of the display, followed by the IP address on the bottom line. To show

the machine’s host name, press .

•If the machine was unable to receive an IP address automatically, or if the router locked up after the machine received an IP address,

[IP ADDRESS/DHCP: FAIL] / [192.168. 1 .201] will appear. “192.168. 1

.201“ is an IP address that is assigned to the machine for diagnostic purposes when connection fails (it cannot be used for regular communication).

• If [NOW CONNECTING / CHECK LATER] appears, press STOP to exit. This message will appear if a cable is not connected or the machine has not yet established communication on the network. Make sure a cable is correctly connected, wait briefly, and then repeat the procedure again.

30