Sharp JW-20CM, JW-20RS [DCM (decimal), word], of SEND/RECEIVE function, “When PC is JW model and the SEND/RECEIVE function is used”

From the previous page

V5

“When PC is JW model and the SEND/RECEIVE function is used”

Set top address in communication information storage area when using data memory system

of SEND/RECEIVE function

· Set file address(8) in parameter addresses 007710 to 007713(8).

	007710(8)	Lower	Top address of communication information
			storage area
	007711(8)	Upper
			(file address)
	007712(8)	File number of communication
		information storage area
	007713(8)	This setting is valid by 80(H)
	“When PC is JW model and the memory capacity save function is used”
	Set the number of sending bytes of the relay link in save memory function			[DCM (decimal), word]
V5

· Set the number of sending bytes in decimal on the parameter address 007720 to 007721(8).

007200(8)	Lower
007721(8)	Upper

		· In case of setting 4 bytes using JW-13PG: Example for slave station 02 of page 9·41
						Display the contents of parameter addresses 007720 to
						007721(8)
					Write 00004(D) after converting to decimal
		Screen display of JW-13PG
			07714	D	00000	007720(8)
			07716	D	00000		00004(D)
			I PARAM.			007721(8)
			>07720	D	00004
		“When PC is JW model and the memory capacity save function is used”
		Set the number of receiving bytes of register link in save memory function
	V5
9
		Set the number of sending bytes in decimal on the parameter address 007722 to 007723(8).

007722(8)Lower

007723(8)Upper

·In case of setting 8 bytes for parameter addresses 007722 to 007723(8) using JW-13PG: Example for slave station 02 of page 9·41

Display the contents of parameter addresses 007722 to 007723(8)

Write 00008(D)

Screen display of JW-13PG

07716	D	00000	007722(8)
07720	D	00004		00008(D)
I PARAM.			007723(8)
>07722	D	00008

To the next page

9·28