Sharp JW-20CM, JW-20RS [3] Setting procedure

9

Whennotusing SEND/RECEIVEfunction

[3] Setting procedure
				In brackets: See page in chapter 9
						[ 39 ]
		Start slave station PC operation
		Turn ON the power of master station PC				[ 39 ]
		Connect support tools				[ 39 ]
		Stop PC operation				[ 39 ]
						[ 39 ]
		Stop operation of data link (007777(8) =00(H))
①						[ 40 ]
		Set top address of the relay link area on the master station
②		Set data link function (004002	(8)	=01	(H)	[ 42 ]
					)
③
		Set number of connecting stations				[ 42 ]
④	Set top address of relay link area on slave station 01 to 77(8) (at standard function)					[ 42 ]
		/number of offset bytes (at memory capacity save function)
						[ 43 ]
⑤		Set top address of register link area on master stations
⑥	Set top address of register link area on slave station 01 to 77(8) (at standard function)					[ 44 ]
		/number of off set bytes (at memory capacity save function)
⑦
		Set number of sending bytes of the master station relay link				[ 45 ]
⑧
					(8)	[ 45 ]
		Set number of sending bytes of the slave station 01 to 77 relay link
⑨
		Set number of sending bytes of the master station register link				[ 46 ]
⑩		Set number of sending bytes of the slave station 01 to 77(8) register link				[ 46 ]
⑪						[ 47 ]
		Set time-out time of SEND/RECEIVE instruction
⑫		Set PC model of each station				[ 48 ]
						[ 49 ]
⑬		Select system of each channel in SEND/RECEIVE function
	V5
		Top address in communication information storage area				[ 50 ]
⑭	V5
		when using data memory starting system of SEND/RECEIVE functions
⑮		Set connection status of slave stations				[ 50 ]
						[ 50 ]
⑯	V5	Whether the station number information should be output or not
						[ 51 ]
⑰		Set top address of flag area
						[ 51 ]
⑱		Set detection time of communication error
⑲						[ 52 ]
		Writing to EEPROM, start operation (007777(8) =81(H))
						[ 52 ]
		PC operation
		End

①to ⑲ correspond to numbers in page 9·33.

9·38