Sharp JW-20CM, JW-20RS manual 144

From the previous page

Set the number of sending bytes of the master station register link [DCM (decimal), word]

•Set the number of sending bytes in decimal on the parameter addresses 005200 to 005201(8).

•These top addresses should not overlap the relay link area or the flag area, or exceed the setting value (0 to 2048 bytes for each station, 2048 bytes for all stations in total).

005200(8)Lower ｝

005201(8)Upper

Enter by decimal

(In case of setting 16 bytes using JW-13PG: Example of page 9·41)

Display the contents of parameter addresses 005200 to
005201(8)	Screen display of JW-13PG
Write 00016(D) in decimal notation.
		05174	D	00000
		05176	D	00000
		I PARAM.
		>05200	D	00016

Set the number of sending bytes of the slave station (01 to 77(8)) register link [DCM (decimal), word]

•Set the number of sending bytes in decimal on the parameter addresses 005202 to 005377(8). (set in each station, 2 bytes for each station).

These top addresses should not overlap the resister link area, or the flag area, or exceed the setting range (0 to 2048 bytes for each station, 2048 bytes for all stations in total).

	Slave	005202(8)		Lower
	station 01		005203(8)	Upper
			to	to
	Slave	005376(8)		Lower
	(8)			Upper
		005377(8)
	station 77
9	(In case of setting 8 bytes both for slave station 01 and 02: example of page 9·41)
	Slave station 01			Write 00008(D) in parameter
				addresses 005202 to 005203(8).
	Slave station 02			Write 00008(D) in parameter
				addresses 005204 to 005205(8).

Screen display of JW-13PG

05200	D	00016
05202	D	00008
I PARAM.
>05204	D	00008

To the next page

9·46