Sharp JW-20CM, JW-20RS manual 216

(7/7)

Address(8)	Set contents						Setting method (value, example)
		007700		CH0				00(H)					Instruction system
								80(H)					Data memory start system
007700	System of each cannel in	007701		CH1				00(H)					Instruction system
to								81(H)					Data memory start system
	SEND/RECEIVE function							00(H)					Instruction system
007703		007702		CH2
								82(H)					Data memory start system
		007703		CH3				00(H)					Instruction system
								83(H)					Data memory start system
		007710											When ｺ1100 to set to 001100(8)
	Top addresses in communication			(Octal, word)
007710		007711											(Set by file address)
to	information storage area when using
	data memory starting system of
007713		007712	(Hexadecimal, byte)										When file number is 0, set to 00(H)
	SEND/RECEIVE functions
		007713	This setting is valid by 80(H)
	Connection condition of slave station	Bit address	7	6	5	4	3	2	1	0				• When connecting slave station 00
		007750	07	06	05	04	03	02	01	00
	• Turn ON the corresponding bit of														to 04(8) and output error code:
007750		007751	17	16	15	14	13	12	11	10
	connected station number (01 to														(Address)	(Bit pattern)
		007752	27	26	25	24	23	22	21	20
to	77(8)) from the list at right.
		007753	37	36	35	34	33	32	31	30					007750 － 00011111
	• 00(8) of master station (0 bit of
007757		007754	47	46	45	44	43	42	41	40					007751 － 00000000
	address 000750)
		007755	57	56	55	54	53	52	51	50
	At ON: Output error code														to		to
		007756	67	66	65	64	63	62	61	60
	At OFF: Do not output error code.														007757 － 00000000
		007757	77	76	75	74	73	72	71	70
007763	Whether the station number information should					00(H)					Do not output
	be output or not
						01(H)					Output
		007764											When ｺ0200, set to 000200(8)
				(Octal, word)
007764															(Set by file address)
		007765
	Flag area top address on the master
to
	station												When file number is 2, set to 02(H)
007767		007766	(Hexadecimal, byte)
															00(H): Do not output flag
		007767
															80(H): Output flag
007771	Communication error detection interval			(Decimal, bytes)								When 600 ms, set to 006(D)
	Stop operation of the data link					00(H)						Set in 100 ms unit
	Start operation of the data link					01(H)
007777
	Writing to EEPROM or operation stop operation					80(H)
	Writing to EEPROM or operation start operation					81(H)
	Initialize parameter setting value					08(H)
																		13

• See page 9·33 for initial value of the addresses above.

13·15