Sharp JW-20CM, JW-20RS (4)Parameter setting of master module (JW-20CM)

(4)Parameter setting of master module (JW-20CM)

Set the following parameter address after setting switch. Setting item varies with using PC (JW model or ZW model).

O:Necessity for setting

	Item	Address	Initial	Setting contents	JW-PC		ZW-PC		See
			value
		(8)			Fixed	Manual	Fixed	Manual	page
			(H)
				001(8): Fixed allocation, asynchronous, error mode 1
				002(8): Fixed allocation, asynchronous, error mode 2
				004(8): Fixed allocation, synchronous, error mode 0
				005(8): Fixed allocation, synchronous, error mode 1
	Set remote I/O	000000	00	006(8): Fixed allocation, synchronous, error mode 2	○	○	○	○	8· 34
	operation mode			011(8): Manual allocation, asynchronous, error mode 1
				012(8): Manual allocation, asynchronous, error mode 2
				014(8): Manual allocation, synchronous, error mode 0
				015(8): Manual allocation, synchronous, error mode 1
				016(8): Manual allocation, synchronous, error mode 2
	Set number of			Set number of connected modules by decimal
	connected slave	000001	00		○	○	○	○	8· 35
				notation (01 to 63)
	stations
	Set remote I/O top	000002	00	Set file address by octal notation	○	○	○	○	8· 35
	address	000003
	Enter the remote I/O	000004
	top address of slave	to	00	Enter the file address by octal notation	－	○	－	○	8· 40
	station 02 to 77	000177
	Enter the number of			00(H): 64 points (8 bytes), number of slave station; 63
		000200	00	01(H): 128 points (16 bytes), number of slave station;	○	－	○	－	8· 38
	slave I/O points
				32
	Enter the number of	000201		Enter the number of bytes of each slave station in
	I/O bytes for each	to	00		－	○	－	○	8· 42
				decimal notation (0 to 128)
	slave station	000277
	Set blank between	000301		Enter the number of blank bytes between stations in
		to	00		○	－	○	－	8· 39
	stations			decimal notation (0 to 255)
		000376
	Enter I/O type for	000400		Set each station in bit unit
8
		to	FF	0: ZW model I/O module	○	○	－	－	8· 43
	each slave station
		000407		1: JW model I/O module
	Enter the data	000600		Set using 4 bytes per module	○	○
	register address of	to	00	(Set slave station number, rack number, slot number,			－	－	8· 44
					※	※
	the special I/O mode	000777		number of data bytes, and register top address.)
	Set top address of	003764
		to	00	Set file address with octal notation.	○	○	○	○	8· 36
	flag area
		003767
				00(H) : Stop remote I/O operation
	Writing to the			01(H) : Start remote I/O operation
	EEPROM, start	003777	01	80(H) : Writing to the EEPROM, stop operation	○	○	○	○	8· 37
	operation/stop setting			81(H) : Writing to the EEPROM, start operation
				08(H) : Initialize the parameter

· If a special I/O module is not set in a slave station, the setting is not required.

8·30