3
User Interface
Displaying function names (address blocks), parameter names and their settings or values (addresses), and subpa- rameter settings (subaddress, where applicable), does not require a password (except for viewing the password itself). Data can be displayed by following steps 1 to 3 of the stan- dard operating procedures described in Table 3.1. Viewing passwords requires the entry of an appropriate level user password (refer to Section 3.3 for more information on passwords).
Configuring parameters requires a password. Use steps 1 and 2 or steps 1 to 3 to display the desired parameter or its subparameters. Continue with step 4 to make changes to this parameter or subparameter.
When leaving a function or before scrolling to the waveform parameters of the same function, the relay prompts to indi- cate the end of the password operation and whether the changes made so far shall be saved. When the message “End of Password Operation ?” appears, press the Yes key to continue to the next function. Press the No key to scroll back through the parameters of this one function. Pressing the Yes key returns the message “SAVE NEW SETTINGS ?”. Press the Yes key again to save the settings, or press the No key to abort any changes made after the last saving proce- dure.
12 | Siemens Energy & Automation, Inc. |
