Tektronix Phasershare Printer manual PhaserShare Networking Manual

PhaserShare Series B Network Interfaces 2

Using PhaserLink Printer Management Software to configure Token Ring

For information on connecting to your printer via PhaserLink Printer Management Software, see “Accessing printer information from a browser” on page 122. For general information on PhaserLink Printer Management Software, see Chapter 12, “PhaserLink Printer Management Software”.

1.From the printer’s home page, click Configuration; this displays the View and Configure Settings page.

2.From the View and Configure Settings page, click View and Configure Interface Settings; this displays the View and Configure Interface Settings page.

3.From the View and Configure Interface Settings page, click View and Configure PhaserShare Settings (Token Ring card); this displays the View and Configure PhaserShare Settings page for Token Ring.

4.Enter your settings into the fields for Token Ring Address, Speed, and Bridging. If you make an error, click Restore Initial Form Values and start again.

5.When you are finished entering the settings, enter the Validation Password and click Do/Apply. If you are not sure of the password, contact your system administrator.

6.You must reset the printer before the changes take effect. For more information, see Chapter 16, “Resetting the Printer”.

PhaserShare Networking Manual 21