Tektronix Phasershare Printer manual Setting IP parameters Phaser 780 printer front panel

7 TCP/IP Printer Configuration (All Platforms)

7.The printer calculates the broadcast address based on the IP address and the network mask. However, the broadcast address can be viewed and set using the following procedure:

a.Press ---->until Broadcast Address is displayed.

b.Press Select; the front panel displays the broadcast address.

c.Use + and ---->as described in Steps 4d through 4f to set the broadcast address.

d.When the broadcast address is set, use Set and Confirm as described in Steps 4g and 4h to enter the broadcast address into the printer.

8.Return the printer to normal operation.

a.Press Exit (the far left button) until the front panel displays Network Settings.

b.Press Exit again.

■If you have changed any parameters that require a printer reset to take effect, you will be prompted to reset the printer. If you press Reset, the printer resets. If you press Resume, the front panel displays Network Settings. Press Exit (the far left button); the printer returns to normal operation, but the changes you have made will not take effect until the next time the printer is reset.

■If you have not changed any parameters that require a printer reset to take effect, the front panel displays Ready.

Setting IP parameters: Phaser 780 printer front panel

N O T E

When you set the IP addressing parameters from the front panel, the front panel selections for DHCP/BOOTP and RARP are automatically set to Disabled.

1.While Ready is displayed, press Select; the Printer menu is displayed:

Printer Menu
Help Pages	Menu

2.Press the left or right arrow buttons until the front panel displays Network Settings.

Printer	Menu
Network	Settings	Menu

3.Press Menu to enter the Network Settings menu; Network Settings appears on the top line of the display.

4.If TCP/IP is not already displayed, press the right arrow button until the front panel displays TCP/IP.

60PhaserShare Networking Manual