Tektronix Phasershare Printer manual Press Menu to display the IP address. For example

TCP/IP Printer Configuration (All Platforms) 7

5.To set the IP address:

a.Press Menu again; the front panel displays Interface.

b.Press the right arrow button until the front panel displays

IP Address.

c.Press Menu to display the IP address. For example:

IP Address

192.2.194.101 Select

N O T E

Setting the IP address to 000.000.000.000 causes the printer to use Dynamic Address Resolution to set its IP address (see “Setting IP parameters: RARP or BOOTP” on page 65).

d.Press the up arrow button to set the left-most digit of the address.

e.Press the right arrow button to advance to the next digit. Press the up arrow button to set this digit.

f.Use the right arrow and up arrow buttons as described in Step e to set the remaining digits.

g.When the address is correctly set, press Select; the front panel displays the IP Address with a Confirm button.

N O T E

When you press Confirm to set the IP address, the printer resets the network mask and broadcast address to the printer’s defaults; see “Printer defaults for network mask and broadcast address” on page 57.

h.Press Confirm; the front panel briefly displays Selected, then displays the IP address again. The IP address is now set in the printer.

i.Press Exit (the far right button); the front panel displays:

TCP/IP
IP Address	Menu

6.To set the network mask:

a.Press the right arrow button until Network Mask is displayed.

b.Press Menu; the front panel displays the network mask.

c.Use the right arrow and up arrow buttons as described in Steps 5d through 5f to set the network mask.

d.When the network mask is set, use Select and Confirm as described in Steps 5g and 5h to enter the network mask into the printer.

e.Press Exit (the far right button); the front panel displays:

TCP/IP
Network Mask	Menu

PhaserShare Networking Manual 61