Chapter

7 TCP/IP Printer

Configuration

(All Platforms)

There are two steps to printer configuration:

1.Set the printer’s IP address and other addressing information. The Phaser 840, 740 and 780 printers support the use of IP host name as well as IP addresses.

2.Set the printer’s other TCP/IP parameters (optional):

Set host access and control character filtering for each port.

Receiving printer status (Syslog, SNMP, or email notification)

Setting the printer’s IP addressing parameters

Obtain the information listed in the following table. It might be helpful to write down this information so that you can refer to it later when you are performing the configuration.

Information for TCP/IP configuration

Information

Comments

Internet (IP) address for the printer

The format is x.x.x.x, where x represents a decimal number from 0 - 255.

 

 

Network mask

If you are unsure, leave this blank; the printer chooses an appropriate mask.

 

 

Broadcast address

If you are unsure, leave this blank; the printer computes an appropriate

 

broadcast address.

 

This is the address the printer uses to send broadcast packets. Regardless

 

of how this parameter is set, the printer accepts broadcast packets from any

 

of the commonly used broadcast address conventions.

 

 

Gateway IP address

This is the address of the router. You need this address if you want to

 

communicate with the printer from anywhere other than the local network

 

segment.

 

 

PhaserShare Networking Manual

55

Page 63
Image 63
Tektronix Phasershare Printer TCP/IP Printer Configuration All Platforms, Setting the printer’s IP addressing parameters