8. LOADING/REPLACING THE MEDIA

EO1-31009

8. LOADING/REPLACING THE MEDIA

2.Move the media guide and the media roll stopper to the right and place a label roll into the label roll holder.

Label Roll Holder

Media Roll Stopper

Media Guide

NOTES: 1. When the inner part of the label roll is protruding, flatten it on a level surface.

2. Do not use labels rolled loose, as this may cause a paper jam. Re-roll the label tightly.

3.Move the media roll stopper to the label edge. Make sure that the label roll stopper’s front part, where the label “ WIDTH” is attached, is set along with the label edge.

Media Roll Stopper

WIDTH

4.Pull the top end of the label past the strip plate so that the labels pass under the pinch roller unit.

Pinch Roller Unit

Strip Plate

8- 2

Page 20
Image 20
Toshiba SL-5300 Series owner manual Label Roll Holder Media Roll Stopper Media Guide