Xantrex Technology manual 3XW Auto Generator Start Bottom Panel

Introduction

Bottom Panel

Network Port

(accepts eight-pin

RJ45 plug)

Network

20-contact Generator Connector Port

CAUTION:

Connect only to Class 2 ELV circuits.

!Refer to manual.

	Figure 1-3XW Auto Generator Start Bottom Panel
Network Port	Each network port can accept an eight-pin RJ45 plug attached to a
	Category 5 (CAT 5) network cable. Depending on the installation, both
	ports may be required.

	CAUTION: Equipment Damage
	Connect the XW Auto Generator Start only to other Xanbus compatible devices.
	Although the cabling and connectors used in this network system are the same as
	those used for Ethernet, this network is not an Ethernet system. Equipment
	damage may result from attempting to connect these two different systems.
20-contact	The 20-contact connector supports a wiring harness (included) that
Connector	connects the XW Auto Generator Start to a generator and thermostats.
	The wiring harness also provides lines for connecting external generator
	shutdown sensors or switches and external generator ON/OFF controls.

Figure 1-4Wiring Harness

1–6 975-0307-01-01