Graphical user interface (GUI) menu

■Control Monitor (Control monitor)

Use this feature to select the HDMI OUT jack at which HDMI control signals are output.

ChoiceFunctions

HDMI OUT1 Outputs HDMI control signals at the HDMI OUT 1 jack.

HDMI OUT2 Outputs HDMI control signals at the HDMI OUT 2 jack.

■Monitor Info. (Monitor information)

Use this feature to check the information (interface and frequency for each video resolution) about the video monitors connected to the HDMI OUT 1 and HDMI OUT 2 jacks of this unit.

y

Press 9h repeatedly to toggle between “OUT1” (information about the video monitor connected to the HDMI OUT 1 jack) and “OUT2” (information about the video monitor connected to the HDMI OUT 2 jack).

Setup (Network)Use this menu to adjust the network parameters.

Note

In case you changed your network configuration, you may need to reconfigure the network settings.

y

You can reset the all parameters in “Network” to the initial factory settings by using “NETWORK” of “INITIALIZE” in “ADVANCED SETUP” (page 131).

■Configuration (Network configurations)

Use this feature to view the network parameters (IP address, etc.) or to change them manually.

DHCP (DHCP setting)

Use this feature to select whether this unit can obtain the network parameters (IP address, subnet mask, default gateway, primary DNS server and secondary DNS server) from the DHCP server of the connected network.

Choice

Descriptions

 

 

On

Select this setting when this unit can obtain the

 

network parameters from the DHCP server of

 

the connected network.

 

 

Off

Select this setting when you set the network

 

parameters manually.

 

 

IP Address (IP address)

Use this parameter to specify an IP address assigned to this unit. This value must not duplicate the one used for other devices in the target network.

Subnet Mask (Subnet mask)Use this parameter to specify the subnet mask value assigned to this unit.

y

For most of the cases, the subnet mask value can be set as “255.255.255.0”.

Default Gateway (Default gateway)Use this parameter to specify the IP address of the default gateway.DNS Server (P) (Primary DNS server)DNS Server (S) (Secondary DNS server)

Use this parameter to specify the IP address of the primary and secondary DNS (Domain Name System) servers.

Note

If you have only one DNS address, enter the DNS address in “DNS Server (P)”. If you have two or more DNS addresses, enter one of them in “DNS Server (P)” and another in “DNS Server (S)”.

■Network Standby (Network standby)

Use this feature to select whether this unit accepts the commands via LAN network when this unit is in the standby mode.

Choice

Descriptions

 

 

Off

Does not accept the operations via LAN

 

network when this unit is in the standby mode.

 

 

On

Accepts the operations via LAN network when

 

this unit is in the standby mode.

 

 

Note

When “Network Standby” is set to “On”, the amount of power consumption in the standby mode increases.

■Information (Network information)Use this feature to display the network system information.MAC Address(MAC (Media Access Control) address)This information displays the MAC address that is assigned to this unit.Status (Network status)This information displays the current link status of the network.Display status: 10BASE-T, 100BASE-TX, No Link, Full Duplex, Half Duplex

Note

“No Link” appears when network connection is not made.

System (System ID)This information displays the system ID that is assigned to this unit.

102 En