Yamaha RX-Z7 19 En, Caution, PREPARATION, ■Connecting the banana plug, ■Connecting the speaker cable, ■Using bi-amplificationconnections

■Connecting the speaker cable

1Remove approximately 10 mm (0.4 in) of insulation from the end of each speaker cable and then twist the exposed wires of the cable together to prevent short circuits.

10 mm (0.4 in)

2Loosen the knob, insert one bare wire into the hole and then tighten the knob.

Loosen Insert Tighten

■Connecting the banana plugTighten the knob and then insert the banana plug into the end of the terminal.

Banana plug

Connections

■Using bi-amplification connections

Caution

Remove the shorting bars or bridges of your speakers to separate the LPF (low pass filter) and HPF (high pass filter) crossovers.

You can make bi-amplification connections to one speaker system which supports bi-amplification connection as shown below. To activate the connections, configure the “BI-AMP” setting (page 131).

This unit

SURROUND BACK/BI-AMP

RL

+

SINGLE

FRONT

RL

+

Right Left

Front speakers

Note

When you make the conventional connection with the speakers, make sure that the shorting bars are put into the terminals of the speakers appropriately. Refer to the instruction manuals of the speakers for details.

PREPARATION

19 En