Use this feature to manually adjust the basic speaker settings. Most of the “Speaker” parameters are set automatically when you run the automatic setup.
y
•Set “Test Tone” to “On” to output the test tone for the “Configuration”, “Distance” and “Level” settings.
•If your subwoofer can adjust the output volume and the crossover frequency, set the volume to about half way (or slightly less) and set the crossover frequency to the maximum.
■Configuration (Speaker configurations)Measure for the speaker sizeThe woofer section of a speaker is–16 cm (6.5 in) or larger: large–smaller than 16 cm (6.5 in): smallFront (Front speakers)Choice | Descriptions |
|
|
Large | Select this setting when the front speakers |
| are large. |
|
|
Small | Select this setting when the front speakers |
| are small. |
|
|
Note
When “Bass Out” is set to “Front” (page 94), you can select only “Large” in “Front”. If the value of “Front” is set to other than “Large” in advance, this unit change the value to “Large” automatically.
Center (Center speaker)Choice | Descriptions |
|
|
Large | Select this setting when the center speaker is |
| large. |
|
|
Small | Select this setting when the center speaker is |
| small. |
|
|
None | Select this setting when you do not use the |
| center speaker. The center channel signals |
| are directed to the front left and right |
| speakers. |
| |
| Surround (Surround left/right speakers) | |
Choice | Descriptions |
|
|
Large | Select this setting when the surround |
| speakers are large. |
|
|
Small | Select this setting when the surround |
| speakers are small. |
|
|
None | Select this setting when you do not use the |
| surround speakers. This unit is set to the |
| Virtual CINEMA DSP mode (page 51), and |
| “Surround Back” is automatically set to |
| “None”. |
|
|
Graphical user interface (GUI) menu
Surround Back(Surround back left/right speakers)Choice | Descriptions |
|
|
Large x1 | Select this setting when the single surround |
| back speaker is large. |
|
|
Small x1 | Select this setting when the single surround |
| back speaker is small. |
|
|
Small x2 | Select this setting when the surround back |
| left and right speakers are small. |
|
|
Large x2 | Select this setting when the surround back |
| left and right speakers are Large. |
|
|
None | Select this setting when you do not use the |
| surround back speakers. The surround back |
| channel signals are directed to the surround |
| left and right speakers. |
|
|
Note
If you are only using one surround back speaker, connect it to the SUR.BACK SINGLE jack, and configure the “Surround Back L” settings under “Distance” and “Level”.
Cross Over (Cross over)Use this feature to select the crossover frequency of the speaker(s) that is set to “Small”. All frequencies below the selected frequency will be sent to the subwoofer or to the speakers set to “Large” in “Configuration”.
Choices: 40Hz, 60Hz, 80Hz, 90Hz, 100Hz, 110Hz, 120Hz, 160Hz, 200HzFront Presence (Front presence speakers)Use this feature if you want to use the front presence speakers connected to this unit.
Choice | Descriptions |
|
|
Yes | Select this setting when you use the front |
| presence speakers. |
|
|
None | Select this setting when you do not use the |
| front presence speakers. |
|
|
Use this feature to switch the phase of your subwoofer if bass sounds are lacking or unclear.
ChoiceFunctions
Normal Does not change the phase of your subwoofer.
Reverse Sets the phase of the subwoofer to reverse.
OPERATION | ADVANCED |
|
|