Yamaha RX-Z7 110 En, Using examples, Press, Press, SYSTEM MEMORY, Press one of the, Saving each setting, Follow steps 1 to 4 in, automatic setup and manual setup

Saving and recalling the system settings (System Memory)

1Press one of the 7SYSTEM MEMORY buttons on the remote control to select the desired memory number.

“Memory1 LOAD” (example) appears in the front panel display.

SYSTEM MEMORY

1 2 3 4

y

“Empty” appears in the menu screen if no system settings are stored in the selected memory number.

2Press the selected 7SYSTEM MEMORY button once more to confirm the selection.This unit loads the settings stored in the selected memory number.■Loading by the GUI menu operation

1Follow steps 1 to 4 in “Saving by the GUI menu operation” (page 108).

2Press 9k / n repeatedly to select “xxx Load” and then press 9h.

“xxx” indicates the zone you selected in step 1.

3Press 9k / n repeatedly to select the desired memory number and then press 9ENTER.

y

If the memory number you selected is empty, “Memory Empty” appears.

4Press 9k / n / l / h repeatedly to select “LOAD” and then press 9ENTER to loadthe settings stored in the selected memory number.

y

To cancel the operation and return to the previous menu, select “CANCEL” and then press 9ENTER.

5Press IMENU to turn off the GUI menu.

Using examples■Example 1: Comparing the results of theautomatic setup and manual setup

This unit is equipped with three types of parametric equalizer settings (page 96), and you can also make your customized configuration of the sound settings of this unit by using the “Speaker” parameters (page 93). To compare the results of the automatic setup or your manual configuration, use the 7SYSTEM MEMORY buttons.

SYSTEM MEMORY 1 Results of the automatic setup (PEQ Select: Natural)

SYSTEM MEMORY 2 Results of the automatic setup (PEQ Select: Front)

SYSTEM MEMORY

1 2 3 4

SYSTEM MEMORY 3

Settings configured manually

Saving each setting1Perform the automatic setup (page 35).2Press and hold 7SYSTEM MEMORY 1 for 4 seconds.

This unit stores the results of the automatic setup (PEQ Select: Natural) to “Memory1”.

3Set “PEQ Select” to “Front” (page 96).4Press and hold 7SYSTEM MEMORY 2 for 4 seconds.

This unit stores the results of the automatic setup (PEQ Select: Front) to “Memory2”.

5Configure the parameters of “Speaker” (page 93) and parametric equalizer configuration of each speaker manually (page 97).

6Press and hold 7SYSTEM MEMORY 3 for 4 seconds.This unit stores the settings configured manually to “Memory3”.

110 En