Troubleshooting
After automatic setupWarning message | Cause | Remedy | See | |
page | ||||
|
|
| ||
W1:Out of Phase | Speaker polarity is not correct. This | Check the speaker connections for proper | ||
| message may appear depending on the | polarity (+ or |
| |
| speakers even when the speakers are |
|
| |
| connected correctly. |
|
| |
|
|
|
| |
W2:Over Distance | The distance between the speaker and the | Bring the speaker closer to the listening | — | |
| listening position is over 24 m (80 ft). | position. |
| |
|
|
|
| |
W3:Level Error | The difference of volume level among | Readjust the speaker installation so that all | — | |
| speakers is excessive. | speakers are set in locations with similar |
| |
|
| conditions. |
| |
|
|
|
| |
|
| Check the speaker connections. | ||
|
|
|
| |
|
| Use speakers of similar quality. | — | |
|
|
|
| |
|
| Adjust the output volume of the subwoofer. | ||
|
|
|
| |
W4:SP Mismatch | The result of “Wiring” checked by the | Manually configure the speaker settings in | ||
| automatic setup is different from the | “Configuration”. |
| |
| settings manually configured in |
|
| |
| “Configuration”. |
|
| |
|
|
|
| |
| “Wiring” has not been checked. | Manually configure the speaker settings in | ||
|
| “Configuration”. |
| |
|
|
|
|
Notes
•If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run perform the automatic setup again.
•If warning message “W2” or “W3” appears, the adjustments are made, however the adjustment may not be optimal.
•Depending on the speakers, warning message “W1” may appears even if the speaker connections are correct.
•If error message “E10” occurs repeatedly, contact a qualified Yamaha service center.