Yamaha RX-Z7 126 En, ■Using TRIGGER OUT jacks for multi-zonecomponents, ■Using REMOTE IN/OUT jacks for multi-zonecomponents

Using multi-zone configuration

■Using REMOTE IN/OUT jacks for multi-zone components

This unit is equipped with two REMOTE IN and REMOTE OUT jacks. You can use these jacks to control this unit and other components from Zone 2, Zone 3 or Zone 4. The following diagram shows an example of the connections.

This unit

				Remote control
				signal out
	REMOTE	IN 1 OUT	IN 2 OUT
				External amplifier
	Remote control
DVD player (etc.)	signal in			Remote control
				(Zone 2)
CD player (etc.)	Remote control
	signal in
				Remote
			Remote control	control
				Infrared signal
			signal out
				receiver

(Zone 3)

y

Some Yamaha models are able to connect directly to the REMOTE jacks of this unit. If you own these products, you may not need to use an infrared signal emitter. Up to 6 Yamaha components can be connected as shown below.

REMOTE		REMOTE			REMOTE			REMOTE
IN		OUT	IN		OUT	IN		OUT
Infrared signal	This unit			Yamaha			Yamaha
receiver				component			component

■Using TRIGGER OUT jacks for multi-zone components

This unit is equipped with two TRIGGER OUT jacks. You can turn on and off the component corresponding to the selection of the input source of the desired zone or turning on and off the desired zone by configuring the “Trigger Output” settings (page 107).

This unit

Trigger in

Trigger in

1 2

TRIGGER OUT

Projector (etc.) in the

main zone

Power amplifier (etc.)

Zone 2 (etc.)

126 En