Using multi-zone configuration

Notes

•To avoid unexpected noise, DO NOT use the Zone 2/Zone 3 feature with CDs encoded in DTS.

•Adjust the second zone and/or third zone volume by using the amplifier in each zone when “Zone2 Volume” or “Zone3 Volume” is set to “Fixed” (page 103).

■Using the internal amplifiers of this unitImportant safety notice

The speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or more than one loudspeaker per channel.

Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low impedance load resulting in amplifier damage. See this owner’s manual for correct usage.

Compliance with minimum speaker impedance information for all channels must be maintained at all times. This information is found on the back panel of your Receiver.

If you want to use one internal amplifier (SP1 or SP2) of this unit

Connect the Zone 2 or Zone 3 speakers directly to the SP1 or SP2 speaker terminals.

If you want to use two internal amplifiers (SP1 and SP2) of this unit

Connect the Zone 2 and Zone 3 speakers directly to the SP1 and SP2 speaker terminals.

PRESENCE/ZONE 2/ZONE 3

 

ZONE 2/ZONE 3

 

R

SP2

L

R

SP1

L

+

 

+

 

 

 

Speakers

Speakers

(Zone 2)

(Zone 3)

This unit

■Connecting zone video monitors

Connect the video monitor(s) in Zone 2, Zone 3 and/or Zone 4 to the ZONE VIDEO and/or COMPONENT VIDEO (MONITOR OUT/ZONE OUT) jacks. If you connect the multiple zone video monitors to these jacks, the video monitors play back the same source simultaneously.

y

To assign the COMPONENT VIDEO (MONITOR OUT/ZONE OUT) jacks to the main zone or another zone, configure the “Component Assign” setting (page 103).

 

Source component

ZONE

MONITOR OUT/

ZONE OUT

VIDEO

 

Y

PB

This unit

PR

V Video In

V Video In

Y

PB

PR Component

 

 

 

 

video in

Video monitor

Video monitor

Video monitor

(Zone 2)

(Zone 3)

 

(Zone 4)

 

OPERATION

ADVANCED

 

 

125 En