Yamaha RX-Z7 96 En, Setup (Sound), Headphone, Control step: 1.0 dB, Control range: –20.0to 0.0 dB, ■Dynamic Range (Dynamic range), Speaker (Speaker dynamic range)

Graphical user interface (GUI) menu

Setup (Sound)Use this menu to adjust the sound parameters.■LFE Level (Low-frequency effect level)

Use this feature to adjust the output level of the LFE (low-frequency effect) channel according to the capacity of your subwoofer or headphones. The LFE channel carries low-frequency special effects which are only added to certain scenes. This setting is effective only when this unit decodes bitstream signals.

Control range: –20.0 to 0.0 dBControl step: 1.0 dBSpeaker (Speaker low-frequency effect level)Select to adjust the speaker LFE level.Headphone(Headphone low-frequency effect level)Select to adjust the headphone LFE level.

Note

Depending on the settings of “Bass Out” (page 94), some signals may not be output at the SUBWOOFER PRE OUT jacks.

■Dynamic Range (Dynamic range)

Use this feature to select the amount of dynamic range compression to be applied to your speakers or headphones. This setting is effective only when the unit is decoding bitstream signals.

Speaker (Speaker dynamic range)Adjusts the dynamic range compression for the speakers.Headphone (Headphone dynamic range)Adjusts the dynamic range compression for the headphones.

Choice	Functions

MAX	Preserves the greatest amount of dynamic
	range.

STD	Adjusts the dynamic range to medium.
	When this unit is decoding Dolby TrueHD
	signals, the dynamic range control is always
	active regardless of the instruction of the
	input source signals.

MIN/AUTO	• MIN: Adjusts the dynamic range to
	narrow when this unit is decoding
	bitstream signals (except Dolby TrueHD).
	• AUTO: Adjusts the dynamic range
	according to the instruction of the input
	source signals when this unit is decoding
	Dolby TrueHD signals.

■Parametric EQ (Parametric equalizer)Use this feature to adjust the parametric equalizer of each speaker.PEQ Data Copy (Parametric equalizer data copy)

Use this feature to copy the result data of the automatic setup to the manual configuration area. You can select the parametric equalizer type applied to the copied result data of the automatic setup. See page 40 for the descriptions of each parametric equalizer type.

ChoiceDescriptions

Flat h Manual Copies the result of the automatic setup that the “Flat” type parametric equalizer is applied to.

Front h Manual Manual Copies the result of the automatic setup that the “Front” type parametric equalizer is applied to.

Natural h Manual Copies the result of the automatic setup that the “Natural” type parametric equalizer is applied to.

PEQ Select (Parametric equalizer type select)

Use this feature to select the parametric equalizer type that applied to the results of the automatic setup. See page 40 for the descriptions of each parametric equalizer type.

Choice	Descriptions

Manual	Applies the manually configured parametric
	equalizer in “Setup”.

Flat	Applies the “Flat” type parametric equalizer.

Front	Applies the “Front” type parametric
	equalizer.

Natural	Applies the “Natural” type parametric
	equalizer.

Through	Does not use the parametric equalizer.

Notes

•When you carry out the automatic setup, this unit automatically set “PEQ Select” to “Natural”.

•“Level” settings (page 94) also change corresponding to the setting of “PEQ Select”.

•This unit does not change the configurations of “Manual” even if you perform the automatic setup.