Parameter

Descriptions

 

 

Equalizing

Parametric equalizer adjusts the level of the

(Speaker

specified frequency bands. This unit

equalizing)

automatically selects the crucial frequency

 

bands for the listening room and adjusts the

 

level of the selected frequency bands to

 

create a cohesive sound field in the room.

 

 

Level

This unit checks and adjusts the volume

(Speaker level)

level of each speaker.

 

 

Angle

Checks the angles of the front speakers,

(Speaker angle)

surround speakers, and front presence

 

speakers.

 

 

Optimizing the speaker setting for your listening room

Note

If an error or warning message appears, see “Error and warning messages” (page 38).

Retry

Exit Detail

Pre Check

E09:User Cancel

Main Check

Wiring

5If you have finished the settings, press 9lto return to the previous menu level and then press 9n to select “Start”.

Before proceeding next operation

Once you perform the next operation, this unit starts the automatic setup procedure in 10 seconds. During the automatic setup procedure, do not perform any operation on this unit. For more accurate measurements, we recommended that you get out of the room or move to the wall where speakers are not around during the measurement. It takes approximately 3 minutes.

6Press 9ENTER to start the measurement.

This unit starts to count down from 10 seconds. y

•To start the measurement immediately, press 9ENTER again.

•To cancel the automatic setup and return to the previous screen, press ?RETURN and then 9ENTER.

Loud test tones are output from each speaker during the measurement.

If you have selected “Angle” in step 4, the following screen appears. Proceed to step 7.

 

 

 

 

 

 

Equalizing

 

 

 

 

Level

Put the microphone at

 

 

Angle Check

1st listening position

 

 

Next:ENTER

 

 

Angle

 

1

 

 

 

 

 

 

Result

3

2

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

If you have not selected “Angle” in step 4, “Measurement Completed Successful” appears once all items are measured. Skip to step 11.

 

 

 

 

 

Angle Check

 

 

 

Angle

Measurement Completed

 

 

Result

Successful

 

 

 

 

 

 

Detail:[ ]

 

 

 

Exit:ENTER

 

 

 

 

 

 

 

 

 

7Place the supplied microphone base at the position you will be seated most frequently.

Make sure that the arrow on the microphone base points the center speaker or about the midpoint between the front left and right speakers.

Microphone base

Note

It is recommended that you use a tripod (etc.) to affix the microphone base at the same height as your ears would be when you are seated in your listening position. You can use the attached screw of a tripod (etc.) to fix the microphone base to the tripod (etc.).

8Place the optimizer microphone to theposition “1” on the microphone base and then press 9ENTER.This unit starts the measurement of the speaker angles.9Move the optimizer microphone to theposition “2”on the microphone base and then press 9ENTER.

PREPARATION

37 En