Troubleshooting
Problem | Cause | Remedy | See | |
page | ||||
|
|
| ||
An audio source | The audio source component is not | Connect the audio source component to the DIGITAL | ||
cannot be recorded by | connected to the DIGITAL INPUT jacks. | INPUT jacks. |
| |
the digital recording |
|
|
| |
Some components cannot records Dolby |
|
| ||
component connected |
|
| ||
to the DIGITAL | Digital or DTS sources. |
|
| |
OUTPUT jacks. | You are trying to record an audio source | Connect the recording component to the analog | ||
| ||||
| input at the DOCK terminal by the digital | AUDIO OUT (DVR, VCR or |
| |
| recording component connected to the |
|
| |
| DIGITAL OUTPUT jacks. |
|
| |
|
|
|
| |
| (U.S.A. model only) | Connect the recording component to the analog | ||
| HD Radio signals are not output at the | AUDIO OUT (DVR, VCR or |
| |
| DIGITAL OUTPUT jacks |
|
| |
|
|
|
| |
An audio source | The audio source component is not | Connect the audio source component to the AUDIO | ||
cannot be recorded by | connected to the analog AUDIO IN jacks. | IN jacks. |
| |
the analog recording |
|
|
| |
XM Satellite Radio and SIRIUS Satellite |
|
| ||
component connected |
|
| ||
to the analog AUDIO | Radio signals are not output at the analog |
|
| |
OUT (DVR, VCR or MD/ | AUDIO OUT (DVR, VCR or |
|
| |
jacks. |
|
| ||
|
|
|
| |
Recorded materials | The settings made on this unit (such as |
|
| |
sound differently. | tonal quality, volume level and sound field |
|
| |
| programs) do not affect recorded material. |
|
| |
|
|
|
| |
The sound field | “Memory Guard” is set to “On”. | Set “Memory Guard” to “Off”. | ||
parameters and some |
|
|
| |
other settings of this |
|
|
| |
unit cannot be |
|
|
| |
changed. |
|
|
| |
|
|
|
|
This unit does not The internal microcomputer has been
operate properly. frozen by an external electric shock (such as lightning or excessive static electricity) or by a power supply with low voltage.
Disconnect the power cable from the AC wall outlet | — |
and then plug it in again after about 30 seconds. |
|
“CHECK SP WIRES” appears in the front panel display.
Speaker cables are | Make sure all speaker cables are connected correctly. |
There is noise | This unit is too close to the digital or high- | Move this unit further away from such equipment. | — |
interference from | frequency equipment. |
|
|
digital or radio |
|
|
|
frequency equipment. |
|
|
|
|
|
|
|
The picture is | The video source uses scrambled or |
|
|
disturbed. | encoded signals to prevent dubbing. |
|
|
|
|
|
|
This unit suddenly | The internal temperature becomes too | Wait about 1 hour for this unit to cool down and then | — |
enters the standby | high and the overheat protection circuitry | turn it back on. |
|
mode. | has been activated. |
|
|
|
|
|
|