Using Bluetooth™ components

You can connect a Yamaha Bluetooth receiver (such as YBA-10, sold separately) to the DOCK terminal of this unit and enjoy the music contents stored in your Bluetooth component (such as a portable music player) without wiring between this unit and the Bluetooth component. You need to perform “pairing” the connected Bluetooth wireless audio receiver and your Bluetooth component in advance.

For details about status messages displayed in the front panel display and in the GUI screen, see “Bluetooth” (page 144).

Note

This unit supports A2DP (Advanced Audio Distribution Profile) Bluetooth profile.

 

While the Bluetooth receiver is in the pairing mode,
Pairing the Bluetooth™ receiver
DOCK indicator flashes in the front panel display.

and your Bluetooth component

y

 

To cancel the pairing, press DENTER (or 9ENTER) again.

 

Pairing must be performed when using a Bluetooth component with the Bluetooth receiver connected to this unit for the first time or if the pairing data has been deleted. “Pairing” refers to the operation of registering a Bluetooth component for Bluetooth communications.

y

•You need the pairing operation only for the first time when you use the Bluetooth component with the Bluetooth receiver.

•Pairing requires operations on this unit and on the other component with which Bluetooth communications are to be established. If necessary, refer to the other component’s operating instructions.

There are two pairing methods: pairing by using “Pairing” in the GUI menu and quick pairing.

■Pairing by using the GUI menu

Use this feature to perform pairing with the GUI screen. For details, see “Pairing” (page 91).

4Check that the Bluetooth component detects the Bluetooth receiver.

If the Bluetooth component detects the Bluetooth receiver, “YBA-10 YAMAHA” (example) appears in the Bluetooth device list.

5Select the Bluetooth receiver in the Bluetooth device list and then enter the pass key “0000” on the Bluetooth component.

When the pairing procedure is successful, “Completed” appears in the front panel display.

Note

The Yamaha Bluetooth receiver can be paired with up to eight Bluetooth components. When pairing is conducted successfully with a ninth component and the pairing data is registered, the pairing data for the least recently used other component is cleared.

OPERATION

BASIC

 

 

■Quick pairing

To ensure security, a time limit of 8 minutes is set for the pairing operation. You are recommended to read and fully understand all the instructions before starting.

1Rotate the LINPUT selector (or set the operation mode selector to FSOURCE and then press 3DOCK) to select “DOCK” as

the input source.

2Turn on your Bluetooth component and then set the Bluetooth component to the pairing mode.

For details about how to operate the Bluetooth component, refer to the manual for it.

3Press and hold DENTER (or 9ENTER) until “Searching” appears in the front panel display.

Playback of the Bluetooth™ component

1Rotate the LINPUT selector (or set the operation mode selector to FSOURCE and then press 3DOCK) to select “DOCK” as

the input source.

2Start playback of your Bluetooth component.

When the connected Bluetooth receiver detects the Bluetooth component, “BT Connected” appears in the front panel display.

y

•When you press 9ENTER on the remote control, the connected Bluetooth receiver searches and connect to the last connected Bluetooth component. If the Bluetooth receiver cannot find the Bluetooth component, “Not found” appears in the front panel display.

•To disconnect the Bluetooth receiver from the Bluetooth component, press 9ENTER.

71 En