y

The results of the measurement that are the causes of the warning message(s) appear in yellow or pink.

Notes

•“–––” appears when no speaker is connected to the corresponding speaker channel or this unit does not measure the corresponding speaker channel yet.

•If you change speakers, speaker positions, or the layout of your listening environment, run the automatic setup again to recalibrate your system.

•The distances displayed in the “Distance” results may be longer than the actual distance depending on the characteristics of your subwoofer or external amplifiers if you connect them.

•In the “Equalizing” results, different values may be set for the same band to provide finer adjustments.

6To reload the displayed parameter, press

9ENTER.

7Press IMENU to turn off the GUI menu.

y

•You can also set the parametric equalizer type with “PEQ Select” (page 96).

•You can set the phase of the connected subwoofer with “Phase” (page 93).

Optimizing the speaker setting for your listening room

PREPARATION

41 En