Use this feature to adjust the tonal quality of each speaker. You can copy the results of the automatic setup for the base of the manual configuration by using “PEQ Data Copy”. Set “PEQ Select” to “Manual” in advance.
1Press 9k / n / l / h to select “Test Tone” or the speaker you want to adjust.Choice | Adjusted speaker |
|
|
Front L | Front left speaker |
|
|
Front R | Front right speaker |
|
|
Center | Center speaker |
|
|
Surround L | Surround left speaker |
|
|
Surround R | Surround right speaker |
|
|
Surround Back L | Surround back left speaker |
|
|
Surround Back R | Surround back right speaker |
|
|
Front Presence L | Front presence left speaker |
|
|
Front Presence R | Front presence right speaker |
|
|
Subwoofer | Subwoofer |
|
|
Use this feature to select whether to turn on or off the test tone output while you are adjusting the tonal quality of each speaker.
Choice | Functions |
|
|
On | Outputs the test tone. |
|
|
Off | Does not output the test tone. |
|
|
|
|
|
|
|
| PEQ Data Copy | PARAM | RESET |
|
| PEQ Select | EDIT | EXIT |
|
|
|
|
| |
| Front L | Band / Gain |
| |
|
|
|
| |
| Front R |
|
|
|
| Center |
|
|
|
|
|
|
|
|
|
|
|
|
|
Graphical user interface (GUI) menu
4Press 9n to select “EDIT” and press 9ENTER to access the edit window.For more information on the parametric equalizer and each parameter, see page 153.PEQ Data Copy | Band | #1 |
PEQ Select | Gain | 0.0dB |
Freq | 62.5Hz | |
Front L | Q | 1.000 |
|
| |
Front R |
|
|
Center |
|
|
| Exit:ENTER | |
y
•When you select “Band” in step 3, you can use this menu as a graphic equalizer.
•“Band #5”, “Band #6”, and “Band #7” can adjust the frequencies of above 500 Hz.
•When you select “Subwoofer” in step 1 and “Band” in step 3, you can adjust “Band #1”, “Band #2”, “Band #3” and “Band #4” only. In this case, “Band #1”, “Band #2”, “Band #3” and “Band #4” adjust the frequencies of below 200 Hz.
5Repeat steps 3 and 4 until you are satisfied with the results.y
If you want to reset all “Parametric EQ” parameter settings
for the selected speaker, select “RESET” and press
9ENTER.
6Select “EXIT” and press 9ENTER to exit from the settings window.■Tone Control (Tone control)Use this feature to adjust the balance of bass and treble output to your speakers or headphones.
Note
Tone Control is not effective when:
–the PURE DIRECT mode (page 54) is selected.
–MULTI CH is selected as the input source.
OPERATION | ADVANCED |
|
|
3Press 9k / n / l / h to select “PARAM” and then press 9ENTER repeatedly to select a
parameter from “Band” (band), “Freq.” (frequency) or “Q” (Q factor).y
You can adjust “Gain” (gain) with any parameter.
ChoiceFunctions
Speaker | Adjust the bass/treble balance of your speakers. |
Headphone Adjust the bass/treble balance of your headphones.
y
“Speaker” and “Headphone” adjustments are stored independently. The adjustments for “Speaker” affects the front left/right speaker, center speaker and subwoofer channels.