Yamaha RX-Z7 39 En, Press, the box, PREPARATION, optimized, skip to step, listening positions are made, Before proceeding next operation, “Basic automatic setup” (page 36)

Optimizing the speaker setting for your listening room

6Press 9k / n repeatedly to set the number of listening positions and press 9l.Choices: 1 (default), 2, 3, 4, 5, 6, 7, 8

Information

Setup Menu

Multi Measure 7

StartWiring

Distance

Note

If an error or warning message appears, see “Error and warning messages” (page 38).

10Move the optimizer microphone to the

second listening position and then press 9ENTER to start the measurement.

To skip the measurements at the remaining listening positions, press 9n.

		11 Repeat step 10 until the measurement at all
	7 To select the parameters to be optimized,
		listening positions are made.
	press 9k / n to select the parameter and
		If you have selected “Angle” in step 7, follow steps 7
	then press 9ENTER to check or uncheck
		to 13 in “Basic automatic setup” (page 36).
	the box.
		If you have not selected “Angle” in step 7,
	When you do not need to select the parameters to be
		“Measurement Completed Successful” appears once
	optimized, skip to step 8.	all items are measured. Follow steps 11 to 13 in
	y	“Basic automatic setup” (page 36).

If you do not select the parameters to be optimized, this unit will optimize the parameters you selected last time. All the parameters except “Angle” are selected by the initial factory settings.

8Press 9l to return to the previous menu level and then press 9n to select “Start”.

Before proceeding next operation

Once you perform the next operation, this unit starts the automatic setup procedure in 10 seconds. During the automatic setup procedure, do not perform any operation on this unit. For more accurate measurements, we recommended that you get out of the room or move to the wall where speakers are not around during the measurement.

9Press 9ENTER to start the measurement.

This unit starts to count down from 10 seconds. y

•To start the measurement immediately, press 9ENTER again.

•To cancel the automatic setup and return to the previous screen, press ?RETURN and then 9ENTER.

Loud test tones are output from each speaker during the measurement. Once all items for the first listening position are measured, the following message appears.

	Pre Check	Put the microphone at
	Main Check	2nd listening position
	Main Check	Next:ENTER
		Next:ENTER
	Wiring	Skip:[ ]
	Distance

PREPARATION