After the connections, turn on this unit and set the speaker terminal assignments with “Zone SP Assign” (page 103).

Controlling Zone 2, Zone 3 or Zone 4

You can select the zone you want to control by using the control buttons on the front panel or on the remote control.

Note

While Zone 4 is turned on, no signal is output at the DVR OUT, VCR OUT and MD/CD-R OUT jacks.

Using multi-zone configuration

Remote control operations1Press HZONE repeatedly to select the zone you want to control.

“MAIN”, “ZONE2”, “ZONE3” or “ZONE4” indicator appears in the display window (D) on the remote control.

(Zone 2)

(Zone 3)

(Zone 4)

(Main zone)

■Basic operationFront panel operations

1Press OZONE 2, OZONE 3 or OZONE 4 on the front panel to turn on or off each zone.

2Press OZONE CONTROLS on the front panel repeatedly to select the zone you want to control.

Each time you press OZONE CONTROLS, the front panel display changes as shown below, and the indicator for the currently selected zone flashes for approximately 10 seconds. However, no indicator flashes when the main zone is selected.

ZONE2 ZONE3 ZONE4

No indicator flashes

when the main zone is selected.

ZONE2Controls the Zone 2 amplifier or tuner functions.ZONE3Controls the Zone 3 amplifier or tuner functions.ZONE4Controls the Zone 4 amplifier and tuner functions

y

You must complete this step within 10 seconds while the selected zone flashes in the front panel display. Otherwise, the currently selected zone mode is automatically canceled.

3Perform the desired operation in the selected zone (page 127).

y

To turn off the desired zone, press OZONE2, OZONE3 or OZONE4 again.

2Press EPOWER to turn on the selected zone.

3Perform the desired operation in the selected zone (page 127).

y

To turn off the desired zone, press DSTANDBY.

■Selecting the input source of Zone 2, Zone 3 or Zone 4

Rotate the LINPUT selector (or set the operation mode selector to FAMP and then press one of the input selector buttons (3)).

•Select “TUNER” as the input source to use the FM/AM tuning features (page 56) in the selected zone.

•Select “XM” as the input source to use the XM Satellite Radio features (page 61) in the selected zone.

•Select “SIRIUS” as the input source to use the SIRIUS Satellite Radio features (page 65) in the selected zone.

•Select “DOCK” as the input source to use the iPod features (page 73) or Bluetooth features (page 71) in the selected zone.

•Select “USB/NET” as the input source to use the USB features (page 76) or network features (page 76) in the selected zone.

Note

The input sources are shared across all zones.

■Adjusting the volume level of Zone 2 or Zone 3Rotate PVOLUME (or press JVOLUME +/–).

y

Press LMUTE on the remote control to mute the sound output to the selected zone.

OPERATION

ADVANCED

 

 

127 En