CYLINDER HEAD

ENG

INSPECTION

Cylinder head

1.Eliminate:

Carbon deposits (from the combustion chambers)

Use a rounded scraper.

NOTE:

Do not use a sharp instrument to avoid dam- aging or scratching:

Spark plug threads

Valve seats

2.Inspect:

Cylinder head Scratches/damage Replace.

3.Measure:

Cylinder head warpage

Out of specification Resurface.

Cylinder head warpage:

Less than 0.05 mm (0.002 in)

Warpage measurement and resurface- ment steps:

Place a straightedge and a feeler gauge across the cylinder head.

Use a feeler gauge to measure the warpage.

If the warpage is out of specification, resurface the cylinder head.

Place a 400 ~ 600 grit wet sandpaper on the surface plate, and resurface the head using a figure-eight sanding pattern.

NOTE:

To ensure an even surface rotate the cylin- der head several times.

4 - 30

Page 153
Image 153
Yamaha WR45OFR service manual Inspection, Cylinder head