Yamaha WR45OFR service manual Hot starter lever holder Bolt hot starter lever holder

HANDLEBAR CHAS

Zero mm (Zero in)

Zero mm (Zero in)

8.Install:

●Start switch 1

●Master cylinder 2

●Master cylinder bracket 3

●Bolt (master cylinder bracket) 4

9 Nm (0.9 m · kg, 6.5 ft · lb)

T . R .

●Clamp 5

NOTE:

●The start switch and master cylinder bracket should be installed according to the dimen- sions shown.

●Install the bracket so that the arrow mark a faces upward.

●First tighten the bolt on the upper side of the master cylinder bracket, and then tighten the

bolt on the lower side.

9.Install:

● Lights switch 1

T .

R .

2 Nm (0.2 m · kg, 1.4 ft · lb)

10.Install:

●“ENGINE STOP” button 1

●Clutch lever holder 2

●Bolt (clutch lever holder) 3

T .

R .

4 Nm (0.4 m · kg, 2.9 ft · lb)

●Hot starter lever holder 4

●Bolt (hot starter lever holder) 5

T .

R .

4 Nm (0.4 m · kg, 2.9 ft · lb)

●Clamp 6

NOTE:

●The “ENGINE STOP” button, clutch lever holder and clamp should be installed accord- ing to the dimensions shown.

●Pass the “ENGINE STOP” button lead in the middle of the clutch lever holder.

5 - 44