Yamaha WR45OFR service manual 58 ~ 0.78, Dcv

TPS (THROTTLE POSITION SENSOR) SYSTEM

ELEC

–+

4.Adjust:

●Idle speed

Refer to “IDLE SPEED ADJUSTMENT” section in the CHAPTER 3.

5.Insert the thin electric conductors 2 (lead) into the TPS coupler 1, as shown, and connect the tester to them.

Tester (+) lead → Yellow lead 3

Tester (–) lead → Black lead 4

CAUTION:

●Do not insert the electric conductors more than required because it may reduce the waterproof function of the coupler.

●Make sure that a short-circuit does not develop between the terminals because it may cause damage to electrical compo- nents.

6.Start the engine.

7.Adjust:

● TPS output voltage

Adjustment steps:

Adjust the installation angle of the TPS 1 to obtain the specified output voltage.

NOTE:

Measure the output voltage accurately with a digital electronic voltmeter that gives an easy reading of a small voltage.

TPS output	Tester selector
voltage	position
0.58 ~ 0.78 V	DCV

6 - 22