Yamaha WR45OFR service manual Spec

CABLE ROUTING DIAGRAM

SPEC

ÏFasten the wire harness, TPS lead (in the wire harness), starter motor lead and negative battery lead to the frame with a plastic locking tie and cut off the tie end.

ÌMake sure that the TPS cou- pler does not go out the chas- sis.

ÓFasten the TPS lead to the frame with a plastic band.

ÈFasten the neutral switch lead and oil hose together with the plastic locking ties and cut off the tie ends.

Ô Pass the cylinder head breather hose through the hose holder.

Fasten the neutral switch lead to the frame with a plastic band ends outward.

ÒFasten the neutral switch lead and AC magneto lead to the frame with a plastic band.

˜ Pass the cylinder head breather hose on the outside of the radiator hose 1 and on the inside of the radiator pipe (radi- ator hose 4).

ˆPass the oil tank breather hose on the outside of the AC mag- neto lead, neutral switch lead, lights switch lead, wire harness and cylinder head breather hose.

ØPass the wire harness on the outside of the neutral switch lead and AC magneto lead.

∏Fit the brake hose into the guides on the protector.

ŒPass the wire harness through the cable guide.

ÂFasten the AC magneto lead, neutral switch lead and lights switch lead to the cable guide at their protecting tube with a plastic locking tie and cut off the tie end.

ÍPass the carburetor breather hoses, overflow hose and cool- ant reservoir tank breather hose so that the hoses do not contact the rear shock absorber.

2 - 24