Yamaha WR45OFR service manual Tighten Pinch bolt handle crown

FRONT FORK CHAS

4.Tighten:

● Pinch bolt (handle crown) 1

T .

R .

23 Nm (2.3 m · kg, 17 ft · lb)

●Pinch bolt (under bracket) 2

T .

R .

20 Nm (2.0 m · kg, 14 ft · lb)

CAUACHTUNG:TION:

Tighten the under bracket to specified torque. If torqued too much, it may cause the front fork to malfunction.

5.Install:

●Brake hose holder 1

●Caliper 2

●Bolt (caliper) 3

T .

R .

23 Nm (2.3 m · kg, 17 ft · lb)

NOTE:

Fit the brake hose holder cut a over the pro- jection b on the front fork and clamp the brake hose.

6.Install:

●Brake hose holder 1

●Bolt (brake hose holder) 2

T .

R .

10 Nm (1.0 m · kg, 7.2 ft · lb)

●Protector 3

●Bolt (protector) 4

T .

R .

10 Nm (1.0 m · kg, 7.2 ft · lb)

NOTE:

When installing the brake hose holder, align the top a of the brake hose neck with the brake hose holder bottom b. Then pass the brake hose 5 in front of the axle boss c and fit it into the hose groove d so that the brake hose does not contact the nut (wheel axle).

7.Adjust:

● Rebound damping force

NOTE:

Turn in the damping adjuster 1 finger-tight and then turn out to the originally set position.

5 - 39