CONTROL FUNCTIONS

GEN INFO

EC157000

REAR BRAKE PEDAL

The rear brake pedal 1 is located on the right side of the machine. Press down on the brake pedal to activate the rear brake.

FUEL COCK

The fuel cock supplies fuel from the tank to carburetor and also filters the fuel. The fuel cock has three positions:

OFF:With the lever in this position fuel will not flow. Always return the lever to this posi- tion when the engine is not running.

ON: With the lever in this position fuel flows to the carburetor. Normal riding is done with the lever in this position.

RES:With the lever in this position fuel flows to the carburetor from the reserve section of the fuel tank after the main supply of the fuel has been depleted. Normal riding is possible with the lever is in this position, but it is recommended to add fuel as soon as possible.

COLD STARTER KNOB

When cold, the engine requires a richer air-fuel mixture for starting. A separate starter circuit, which is controlled by the cold starter knob 1, supplies this mixture. Pull the cold starter knob out to open the circuit for starting. When the engine has warmed up, push it in to close the circuit.

HOT STARTER LEVER

The hot starter lever 1 is used when starting a warm engine.

Use the hot starter lever when starting the engine again immediately after it was stopped (the engine is still warm). Pulling the hot starter lever injects secondary air to thin the air-fuel mixture temporarily, allowing the engine to be started more easily.

1 - 12

Page 28
Image 28
Yamaha WR45OFR service manual Rear Brake Pedal, Fuel Cock, Cold Starter Knob, HOT Starter Lever