Yamaha WR45OFR service manual Pad pin 18 Nm 1.8 m kg, 13 ft lb

REAR BRAKE PAD INSPECTION AND REPLACEMENT

INSP

ADJ

●Remove the pad pin 6 and brake pads 7.

●Connect the transparent hose 8 to the bleed screw 9 and place the suitable con- tainer under its end.

●Loosen the bleed screw and push the cali- per piston in.

CAUTION:

Do not reuse the drained brake fluid.

●Tighten the bleed screw.

T .

R .

Bleed screw:

6 Nm (0.6 m • kg, 4.3 ft • lb)

●Install the brake pad 0 and pad pin A.

NOTE:

●Install the brake pads with their projec- tions a into the caliper recesses b.

●Temporarily tighten the pad pin at this point.

●Install the caliper B and rear wheel C. Refer to “FRONT WHEEL AND REAR WHEEL” section in the CHAPTER 5.

●Tighten the pad pin D.

T .

R .

Pad pin:

18 Nm (1.8 m • kg, 13 ft • lb)

●Install the pad pin plug E and protector F.

T .

R .

Pad pin plug:

3 Nm (0.3 m • kg, 2.2 ft • lb) Bolt (protector):

7 Nm (0.7 m • kg, 5.1 ft • lb)

3 - 31