FRONT BRAKE AND REAR BRAKE CHAS

4.Install:

Pin 1

Plain washer 2

Cotter pin 3 New

NOTE:

After installing, check the brake pedal height. Refer to “REAR BRAKE ADJUSTMENT” sec- tion in the CHAPTER 3.

Front brake hose

1.Install:

Brake hose 1

T .

R .

10 Nm (1.0 m · kg, 7.2 ft · lb)

To brake hose holder 2.

NOTE:

Before tightening the bolt (brake hose holder), align the top a of the brake hose neck with the brake hose holder bottom b. Then pass the brake hose in front of the axle boss c and fit it into the hose groove d so that the brake hose does not contact the nut (wheel axle).

2.Install:

Hose cover 1

Plain washer 2

Bolt [hose cover (M8)] 3

T .

R .

16 Nm (1.6 m · kg, 11 ft · lb)

Bolt [hose cover (M6)] 4

T .

R .

7 Nm (0.7 m · kg, 5.1 ft · lb)

3.Pass the brake hose through the hose guide 1, then through the guide a on the protector 2.

5 - 23

Page 248
Image 248
Yamaha WR45OFR service manual Front brake hose