CABLE ROUTING DIAGRAM

SPEC

1 Hot starter cable

I Rectifier/regulator bracket

2 Clutch cable

 

3 Throttle cable (return)

Å Pass the throttle cables, clutch

4 Throttle cable (pull)

cable and hot starter cable through

5 Ignition coil

the cable guides.

6Negative battery lead ı Pass the throttle cables, clutch

7 Starter motor lead

cable and hot starter cable between

8 Coolant reservoir tank

the radiator and frame, then over

breather hose

the middle radiator mounting boss.

9 Rectifier/regulator

Ç Pass the throttle cables and clutch

0 Cable holder

cable on the outside of the ignition

A Coolant reservoir hose

coil.

BRectifier/regulator lead Î Pass the carburetor breather hose

C Clamp

(throttle cable cover) through the

D CDI unit lead

hose holder.

E CDI unit

Fasten the coolant reservoir tank

F CDI unit band

breather hose and carburetor

G CDI unit stay (frame)

breather hoses together with a

H Cable bracket

plastic locking tie.

ÏFasten the grommet of the clutch cable with the cable holder.

ÌFasten the CDI unit lead to the frame with a plastic locking tie ends at the lower of the frame and cut off the tie end.

ÓInsert the CDI unit band over the CDI unit stay (frame) as far as pos- sible.

ÈFasten the starter motor lead and negative battery lead to the cable bracket in its slot with a plastic lock- ing tie and cut off the tie end.

ÔFasten the rectifier/regulator lead to the rectifier/regulator bracket with a plastic locking tie and cut off the tie end.

2 - 25

Page 62
Image 62
Yamaha WR45OFR service manual Spec