4 - 16
ENG
CARBURETOR
8. Install:
●Throttle shaft assembly 1
●Plain washer (metal) 2
●Plain washer (resin) 3
●Valve lever 4
NOTE:
●Apply the fluorochemical grease on the bear-
ings.
●Fit the projection a on the throttle shaft
assembly into the slot b in the TPS (throttle
position sensor).
●Make sure the stopper c of the spring fits
into the recess in the carburetor.
●Turn the throttle shaft assembly left while
holding down the lever 1 5 and fit the throt-
tle stop screw tip d to the stopper e of the
throttle shaft assembly pulley.
1234
b
a
c
e
d
5
9. Install:
●Push rod 1
NOTE:
While holding down the lever 1 2, insert the
push rod farthest into the carburetor.
1
2
10.Install:
●Starter jet 1
●Pilot jet 2
●Spacer 3
●Needle jet 4
●Main jet 5