Yamaha WR45OFR Bolts cylinder head, 2nd, 20 Nm 2.0 m kg, 14 ft lb, Final, Specified angle 180˚

CYLINDER HEAD

ENG

1

2

180˚

●Remove the bolts.

●Again apply the molybdenum disulfide grease on the threads and contact sur- faces of the bolts and on both contact sur- faces of the plain washers.

●Retighten the bolts.

NOTE:

Tighten the bolts to the specified torque in two or three steps in the proper tightening sequence as shown.

	Bolts (cylinder head):
.	2nd:
T	20 Nm (2.0 m • kg, 14 ft • lb)
R
.

●Put a mark on the corner 1 of the bolt (cylinder head) and the cylinder head 2 as shown.

NOTE:

Tighten the bolts 90˚ in each of the two steps to reach the specified angle of 180˚ in the proper tightening sequence as shown.

	Bolts (cylinder head):
.	Final:
T	Specified angle 180˚
R
.

3.Install:

● Nut (cylinder head) 1

T .

R .

10 Nm (1.0 m · kg, 7.2 ft · lb)

4. Install:

● Copper washer 1 New

●Oil delivery pipe 2

●Union bolt (M8) 3

T .

R .

18 Nm (1.8 m · kg, 13 ft · lb)

●Union bolt (M10) 4

T .

R .

20 Nm (2.0 m · kg, 14 ft · lb)

4 - 32