Yamaha WR45OFR service manual Throttle Lubrication, HOT Starter Lever Adjustment

THROTTLE LUBRICATION/ HOT STARTER LEVER ADJUSTMENT

INSP

ADJ

NOTE:

Before adjusting the throttle cable free play, the engine idle speed should be adjusted.

WARNING

After adjusting the throttle cable free play, start the engine and turn the han- dlebar to right and left and make sure that the engine idling does not run faster.

THROTTLE LUBRICATION

1.Remove:

●Cover (throttle cable cap) 1

●Cover (grip cap) 2

●Throttle cable cap 3

2.Apply:

●Lithium soap base grease On the throttle cable end a.

3.Install:

●Throttle cable cap

●Screw (throttle cable cap)

T .

R .

4 Nm (0.4 m · kg, 2.9 ft · lb)

●Cover (grip cap)

●Cover (throttle cable cap)

HOT STARTER LEVER ADJUSTMENT

1.Check:

●Hot starter lever free play a Out of specification → Adjust.

Hot starter lever free play a: 3 ~ 6 mm (0.12 ~ 0.24 in)

2.Adjust:

● Hot starter lever free play

Hot starter lever free play adjustment steps:

●Loosen the locknut 1.

●Turn the adjuster 2 until free play a is within the specified limits.

●Tighten the locknut.

NOTE:

After adjustment, check proper operation of hot starter.

3 - 11