Yamaha WR45OFR Front Brake PAD Inspection and Replacement, Do not reuse the drained brake fluid

FRONT BRAKE PAD INSPECTION AND REPLACEMENT

INSP

ADJ

●Loosen the pad pin 2.

●Remove the brake hose holder 3 and cal- iper 4 from the front fork.

●Remove the pad pin and brake pads 5.

●Connect the transparent hose 6 to the bleed screw 7 and place the suitable con- tainer under its end.

●Loosen the bleed screw and push the cali- per piston in.

CAUTION:

Do not reuse the drained brake fluid.

●Tighten the bleed screw.

T .

R .

Bleed screw:

6 Nm (0.6 m • kg, 4.3 ft • lb)

●Install the brake pads 8 and pad pin.

NOTE:

●Install the brake pads with their projec- tions a into the caliper recesses b.

●Temporarily tighten the pad pin at this point.

●Install the brake hose holder 9 and cali- per 0 and tighten the pad pin A.

NOTE:

Fit the brake hose holder cut c over the projection d on the front fork and clamp the brake hose.

T .

R .

Bolt (caliper):

23 Nm (2.3 m • kg, 17 ft • lb) Pad pin:

18 Nm (1.8 m • kg, 13 ft • lb)

3 - 29