Lantronix MSS manual Change 80211 Power, Change 80211 Region

Command Reference Change 80211

2.2.8 Change 80211 Power

 DEFAULT 

CHANGE 80211 POWER 

 num 

Controls the card’s transmit power settings. The numeric power setting specified must exactly match a value supported by the card.

Any configuration changes you make will not take place until you issue the Change 80211 Reset command.

Restrictions	Requires privileged user status.
	Only applies to the MSS-VIA and certain MSS4 models.
Errors	If you enter a command that is not applicable to the 802.11 card currently in
	use, you will receive an Error message.
Parameters	Default
	Sets the card to its default transmit power setting.
	num
	Enter a specific milliWatt power setting.
Examples	Local>> CHANGE 80211 POWER DEFAULT
	Local>> CHANGE 80211 RESET
See Also	Show 80211, page 2-63

2.2.9 Change 80211 Region

	FCC	
		
	IC	
		
	ETSI	
CHANGE 80211 REGION 		
	SPAIN	
		
	FRANCE 
	MKK	
		

Sets the regulatory region under which you will operate the MSS. Users in the United States can leave this at the default setting (FCC). Other users should set it to correspond with their region.

Any configuration changes you make will not take place until you issue the Change 80211 Reset command.

Restrictions	Requires privileged user status.
	Only applies to the MSS-VIA and certain MSS4 models.
Errors	If you enter a region that will not work with your 802.11 card, an error bit will
	be displayed when you enter the Show 80211 command.

2-7