Agilent Technologies E1300B, E1301B INITiate IMMediate, Related Commands ABORt, TRIGger, Init

		INITiate [:IMMediate]
INITiate	The INITiate command subsystem controls the initiation of the trigger system
	for one or more trigger cycles. INITiate enables while ABORt disables the
	trigger system. The TRIGger command subsystem controls the behavior of the
	trigger system while it is enabled.
Subsystem Syntax	INITiate
	[:IMMediate]
[:IMMediate] INITiate:IMMediate changes the trigger system from the Idle state to the Wait
	For Trigger state.
Comments	• If TRIGger:SOURce is IMMediate, the Pacer starts. If TRIG:SOURce is
	BUS, EXT, or HOLD, the Pacer will start when that trigger condition is
	satisfied.
	• Sending the ABORt command will reset the trigger system back to its
	Idle state and terminate any pacer pulse train in progress.
	• Sending INIT while the system is still in the Wait for Trigger state
	(already INITiated) will cause an error -213,"Init ignored".
	• Related Commands: ABORt, TRIGger
	• *RST Condition: Trigger system is in the Idle state.
Example Initiating the trigger system (Wait For Trigger state).
	TRIG:SOUR HOLD	trigger source is TRIG
		command
	SOUR:PULS:COUN 1E3	output 1000 Pacer pulses
	SOUR:PULS:PER .1 S	pulse period set to .1 second
	INIT	go to Wait For Trigger state
	TRIG	trigger the Pacer to output
		pulses
	.
	.
	INIT	must re-initiate system before

each trigger cycle

TRIG

.

.

System Instrument Command Reference 7-29