Agilent Technologies E1300B STATus OPERation CONDition?, Statopercond?, Numeric 256 None

STATus :OPERation :CONDition?

STATus	The STATus subsystem commands access the condition, event, and enable
	registers in the Operation Status group and the Questionable Data group.
Subsystem Syntax	STATus
	:OPERation
	:CONDition?
	:ENABle < event>
	:ENABle?
	[:EVENt]?
	:PRESet
	:QUEStionable
	:CONDition?
	:ENABle < event>
	:ENABle?
	[:EVENt]?

:OPERation STATus:OPER:COND? returns the state of the condition register in the

:CONDition?	Operation Status group. The state represents conditions which are part of an
	instrument’s operation.
Comments	• Bit 8 in the register is used by the System Instrument (Command
	Module) to indicate when an interrupt set up by the DIAG:INTerrupt
	commands has been acknowledged.
	• Reading the condition register does not change the setting of bit 8. Bit 8
	is cleared by the DIAG:INT:RESP? command.
	• Related Commands: STAT:OPER:ENABle, STAT:OPER:EVENt?
Example Reading the contents of the condition register
	STAT:OPER:COND?	query register
	enter statement

:OPERation:ENABle < event>

Parameters

STATus:OPER:ENABle < event> sets an enable mask to allow events monitored by the condition register and recorded in the event register, to send a summary bit to the Status Byte register (bit 7).

Parameter	Parameter	Range of	Default
Name	Type	Values	Units
event	numeric	256	none

Comments	• Bit 8 in the condition register is used by the system instrument
	(Command Module) to indicate when an interrupt set up by the
	DIAG:INTerrupt commands has been acknowledged.

7-32 System Instrument Command Reference