Agilent Technologies 75000 SERIES B, E1301B, E1300B user manual 2110

Error Messages and Causes

Code	Message	Cause
2110	Config error 10, Insufficient	Too many instruments installed for the amount
	system memory	of RAM installed in the mainframe. Cannot
		configure instruments. Only the system
		instrument is started.
2111	Config error 11, Invalid	A device’s logical address is not a multiple of 8
	instrument address	and the device is not part of a combined
		instrument.
2113	Config error 13, Logical	Duplicate logical addresses set or interrupt
	address or IACK switch set	bypass switches set improperly. Only the system
	wrong	instrument is started.
2129	Config warning, Sysfail	A device was asserting SYSFAIL on the
	detected	backplane during startup.
2130	Config error 30, Pseudo	A physical device has the same logical address as
	instrument logical address	IBASIC (240)
	unavailable
2131	Config error 32, File system	Insufficient system resources to allow the
	start up failed	IBASIC file system to start.
2145	Config warning, Non-volatile	NVRAM was corrupted or a cold boot was
	RAM contents lost	executed.
2148	Config warning, Driver RAM	Driver RAM was corrupted or a cold boot was
	contents lost	executed.
2202	Unexpected interrupt from	A register based card interrupted when an
	non-message based card	interrupt service routine had not been set up.
2809	Interrupt line has not been	A DIAG:INT:ACT or DIAG:INT:RESP
	set up	command was executed before setting the
		interrupt with DIAG:INT:SET.

B-4 Error Messages