Agilent Technologies 75000 SERIES B, E1301B Is not being displayed press Utils then Selinst

Using the Other Instrument Menus

The instrument menus allow you to access the most-used instrument functions or to monitor an instrument (monitor mode) while it is being controlled from remote. We’ll use the Switchbox menu to show you how to use the instrument menus. Menus are available for many but not all instruments. See “Instrument Menus”, later in this chapter, for more information on a particular instrument’s menu. The Switchbox menu allows you to:

•Open and Close Channels

•Scan Channels

•Display Module Type and Description

•Monitor a Switchbox

•Reset a selected switch module

Selecting the Switchbox To select the Switchbox, press the function key (f1 - f5) corresponds to the label

	SWITCH in the “Select an instrument” menu. (If the “Select an instrument” menu
	is not being displayed press UTILS then SEL_INST.)
Note
	After you press the function key for SWITCH, the screen may show: “Select
	SWITCH at logical address:_” while the screen labels show two or more logical
	addresses. This means more than one Switchbox is installed in the mainframe.
	To select one of the Switchboxes, press the function key for the logical address
	key label.

The charts on the following pages show how to use the Switchbox menu. Keep the following points in mind when using the menu:

•The card number identifies a module within the Switchbox. The module with the lowest logical address is always card number 01. The module with the next successive logical address is card number 02 and so on.

•The @ character is required preceding a channel list when executing a Switchbox command from the terminal interface or remote. When entering a channel list in response to a menu prompt however, do not precede it with the @ character. Doing so causes a syntax error.

3-8 Using the Display Terminal Interface