Agilent Technologies E1301B, E1300B, 75000 SERIES B Start-up Error Messages, Error Messages B-5

Start-up Error Messages

Start-up errors are most often generated just after the mainframe is powered-up or re-booted (DIAG:BOOT command). If you have an Agilent E1301B, or an Agilent E1300B with a terminal connected to the Display Terminal Interface (built-in RS-232 only), you can read these errors on the front panel or terminal. If you have an Agilent E1300B and no terminal, then you must access this error information by sending the VXI:CONF:DLIS? command over GPIB. We recommend that users of either model include a routine at the beginning if their application program which checks for start-up errors before the program trys to access individual instruments. See your Installation and Getting Started Guide for an example program.

Table B-3. Start-up Error Messages and Warnings

Start-Up Error Messages and Warnings

Code	Message	Cause
1	Failed Device	VXI device failed its self test.
2	Unable to combine device	Device type can not be combined into an
		instrument such as a scanning voltmeter or a
		switchbox.
3	Config warning, Device	ID of device does not match list of drivers
	driver not found	available. Warning only.
5	Config error 5, A24 memory	More A24 memory installed in the mainframe
	overflow	than can be configured into the available A24
		memory space.
8	Config error 8, Inaccessible	An A24 memory device overlaps a memory
	A24 memory	space reserved by the mainframe’s operating
		system.
10	Config error 10, Insufficient	Too many instruments installed for the amount
	system memory	of RAM installed in the mainframe. Cannot
		configure instruments. Only the system
		instrument is started.
11	Config error 11, Invalid	A device’s logical address is not a multiple of 8
	instrument address	and the device is not part of a combined
		instrument.
13	Config error 13, Logical	Duplicate logical addresses set or interrupt
	address or IACK switch set	bypass switches set improperly. Only the system
	wrong	instrument is started.
29	Config warning, Sysfail	A device was asserting SYSFAIL on the
	detected	backplane during startup.
30	Config error 30, Pseudo	A physical device has the same logical address as
	instrument logical address	IBASIC (240)
	unavailable
31	Config error 32, File system	Insufficient system resources to allow the
	start up failed	IBASIC file system to start.
45	Config warning, Non-volatile	NVRAM was corrupted or a cold boot was
	RAM contents lost	executed.
48	Config warning, Driver RAM	Driver RAM was corrupted or a cold boot was
	contents lost	executed.

Error Messages B-5