Agilent Technologies E1301B TRIGgerIMMediate, Triggering the Pacer, Discrete NEGative None

TRIGger[:IMMediate]

[:IMMediate] TRIGger:IMMediate will cause a trigger cycle to occur immediately, provided

	that the trigger system has been initiated (INITiate).
Comments	• Related Commands: ABORt, INITiate
	• *RST Condition: This command is an event and has no *RST condition.
Example	Triggering the Pacer.
	TRIG:SOUR HOLD	trigger source is TRIG
		command
	SOUR:PULS:COUN 1E3	output 1000 Pacer pulses
	SOUR:PULS:PER .1 S	pulse period set to .1 second
	TRIG:DELAY .75 S	start Pacer .75 sec after trigger
	INIT	go to Wait For Trigger state
	TRIG	trigger Pacer to output pulses.

:SLOPe TRIGger:SLOPe < slope> is for SCPI compatibility. The mainframe’s "Event In" signal only triggers on a negative going edge.

Parameters	Parameter	Parameter		Range of	Default
	Name	Type		Values	Units
	slope	discrete		NEGative	none
Comments	• Trying to set … SLOPe to other than NEG will generate an error.
	• Related Commands: ABORt, INITiate,
:SLOPe?	TRIGger:SLOPe? returns the current trigger slope setting. Since the
	mainframe’s "Event In" signal only triggers on a negative going edge,
	TRIG:SLOP? will always return "NEG".
:SOURce	TRIGger:SOURce < trig_source>		configures the trigger system to respond to
	the specified source.
Parameters
	Parameter	Parameter		Range of	Default
	Name	Type		Values	Units
	trig_source	character		BUS EXT HOLD IMM	none

7-52 System Instrument Command Reference