Agilent Technologies E1301B, E1300B, 75000 SERIES B user manual Output 70900*SRE

*RCL < state number> Recall stored state. Recalls a stored state from memory and configures the instrument to that state. States are stored using the *SAV command.

Example	OUTPUT 70900;"*RCL 4"	Recalls instrument state
		number 4

*RMC < name_string> Remove Individual Macro Command. Purges an individual macro identified by the name_string parameter.

Example	output 70900;"*RMC ’LIST’"	remove macro command from
		*DMC example

NOTE: At printing time, *RMC is a command proposed for a revision and re-designation of ANSI/IEEE Std 488.2-1987.

*RST Reset. Resets an instrument as follows:

•Sets the instrument to a known state (usually the power-on state)

•Aborts all pending operations

•Disables the *OPC and *OPC? modes.

*RST does not affect:

•The state of the GPIB interface

•The GPIB address

•The output queue

•The Service Request Enable Register

•The Standard Event Status Enable Register

•The power-on flag

•Calibration data

•Protected user data

*SAV < state number> Store state. Stores an instrument’s present state in a numbered memory location (< state number> parameter). State numbers can range from 0 to 9.

Example	OUTPUT 70900;"*SAV 4"	Saves present instrument state
		as state number 4

*SRE < mask> Service Request Enable. When a service request event occurs, it sets a corresponding bit in the Status Byte Register (this happens whether or not the event has been enabled (unmasked) by *SRE). The *SRE command allows you to identify which of these events will assert an GPIB service request (SRQ). When an event is enabled by *SRE and that event occurs, it sets a bit in the Status Byte Register and issues an SRQ to the computer (sets the GPIB SRQ line true). You enable an event by specifying its decimal weight for < mask> . To enable more than one event, specify the sum of the decimal weights. Refer to "The Status Byte Register" earlier in this chapter for a table showing the contents of the Status Byte Register.

Example	OUTPUT 70900;"*SRE 160"	Enables bits 5 & 7. Respective
		weights are 32 + 128 = 160

7-70 System Instrument Command Reference